AER-TRN-01-P02 / Configuration decision and permitted recovery Concept draft 1.0 Fictional inert trainer only; source/training reviewer approval required before training use. No operational aircraft, OEM, qualification, licence-credit or release authority. 1. Resume the reviewed checkpoint Confirm the accepted access/support state from P01. Evidence: The task starts at a recorded checkpoint. Hold/limit: An unknown state requires HOLD and reset/review. 2. Read both candidate identities Compare TRN-210A and TRN-210B in the approved concept illustration. Evidence: Two distinct identifiers are recorded. Hold/limit: The two source GLBs contain A only; B is not silently invented as another measured model. 3. Read the permitted list Use the unchanged list in TRN-LRU-01: A permitted; B excluded. Evidence: The choice refers to the lesson source. Hold/limit: Appearance alone does not establish applicability. 4. Choose and explain State which candidate this lesson permits and why. Evidence: A is selected with a source-based explanation. Hold/limit: Choosing B triggers the hold branch. 5. Hold an excluded choice Stop the authored exercise if B was selected. Evidence: The reason and last accepted checkpoint are retained. Hold/limit: Do not force a fit or quietly amend the list. 6. Capture the discrepancy Record candidate identity, article, lesson revision and the mismatch. Evidence: The instructor can review a bounded discrepancy. Hold/limit: Missing identity evidence prevents continuation. 7. Obtain disposition The source/training reviewer confirms the next permitted step. Evidence: The review is explicit; B stays excluded. Hold/limit: A website message is not an engineering disposition. 8. Recover to permitted A Reset to the accepted checkpoint and select confirmed A. Evidence: A choice and the recovery path are visible. Hold/limit: Do not erase the earlier wrong choice or hints. 9. Check the rail path Confirm the planned harness clearance, support and R1/R2 alignment. Evidence: The sequence can be explained before the model state changes. Hold/limit: Obstruction or inadequate support requires HOLD. 10. Inspect A alignment Use the same model identity and the withdrawn view to inspect the intended rail relationship. Evidence: A aligns with the source rail geometry. Hold/limit: Normalized geometry does not establish real interchangeability. 11. Inspect the seated reference Compare with the original closed/seated reference and record remaining restoration work. Evidence: The intended seated state is identified. Hold/limit: No latch, connector or aircraft acceptance follows from this state alone. 12. Retain decision evidence Keep chosen ID, wrong-choice branch, disposition and recovery explanation for P03. Evidence: The instructor can assess the decision and gaps. Hold/limit: Do not issue an automatic competence or task-release result.